Application Instructions

Surface Treatment ( Positive and Negative Side)

Application Instructions:

1. With a concrete brush, use an aggressive circular motion to coat the concrete with the Krystol T1® slurry mix. Allow Krystol T1® to harden (generally 3 hours).
2. With a concrete brush, use an agressive circular motion to overcoat the Krystol T1® application with Krystol T2® .

Note: Concrete must be free from paints, sealers, oil, grease, bitumen, laitance and other contaminants. Surfaces to be treated must be pre-wet to a saturated-surface-dry (SSD) condition. Do not leave any standing water.

For more detailed suface preparation, please read Technical Bulletin 170.

Application Details:
-- Select an Application Detail -- Crack Repair - Negative side Crack Repair - Positive side ---------------------------------- Joint Repair - Wall to wall (vertical) Joint Repair - Slab to slab Joint Repair - Wall to slab Joint Repair - Slab to wall ---------------------------------- New Cast-in-Place Joint - Wall to wall (vertical) New Cast-in-Place Joint - Slab to slab New Cast-in-Place Joint - Wall to slab New Cast-in-Place Joint - Slab to wall ---------------------------------- New Shotcrete Joint - Wall to wall (vertical) New Shotcrete Joint - Wall to wall (horizontal) - Grout only New Shotcrete Joint - Wall to wall (horizontal) - Treatment only New Shotcrete Joint - Slab to slab New Shotcrete Joint - Wall to slab (wall sits on slab) New Shotcrete Joint - Slab to wall (slab is inboard of the wall) ---------------------------------- Surface Treatment - Positive side Surface Treatment - Negative side

Back to Top

	MATERIALS Krystol T1® Krystol T2® Clean water supply TOOLS Mixing bucket Drill with paddle mixer Natural bristle concrete brush High-pressure water blaster

For more detailed application instructions: