Application Instructions

Horizontal Joints in Shotcrete Walls - Treatment only

Application Instructions:

1. Apply Krystol Waterstop Treatment™ coat to the intended joint area of the existing concrete using a concrete brush. Employ a circular, scrubbing motion so as to achieve maximum adhesion and penetration.
2. Treatment must not be allowed to set up hard before subsequent layer of shotcrete is shot onto it.  Subsequent layer of shotcrete must be shot within ½ hour of Treatment application.

Note: Surfaces to be treated must be pre-wet to a saturated-surface-dry (SSD) condition. Do not leave any standing water.

For more detailed application instructions, please read Technical Bulletin 105.

Application Details:
-- Select an Application Detail -- Crack Repair - Negative side Crack Repair - Positive side ---------------------------------- Joint Repair - Wall to wall (vertical) Joint Repair - Slab to slab Joint Repair - Wall to slab Joint Repair - Slab to wall ---------------------------------- New Cast-in-Place Joint - Wall to wall (vertical) New Cast-in-Place Joint - Slab to slab New Cast-in-Place Joint - Wall to slab New Cast-in-Place Joint - Slab to wall ---------------------------------- New Shotcrete Joint - Wall to wall (vertical) New Shotcrete Joint - Wall to wall (horizontal) - Grout only New Shotcrete Joint - Wall to wall (horizontal) - Treatment only New Shotcrete Joint - Slab to slab New Shotcrete Joint - Wall to slab (wall sits on slab) New Shotcrete Joint - Slab to wall (slab is inboard of the wall) ---------------------------------- Surface Treatment - Positive side Surface Treatment - Negative side

Back to Top