Application Instructions

Horizontal Joints in Shotcrete Walls - Grout only

Application Instructions:

1. Tightly pack the Krystol Waterstop Grout™ against the intersection where the top of the existing shotcrete cold joint meets the shoring wall. Using a trowel, ensure that the grout covers an area minimum one inch above the shoring wall and one inch down the existing shotcrete cold joint.  The minimum thickness of the shotcrete joint at the intersection should be ¾ inch thick.
2. Allow for the grout to harden for minimum 3 hours before the subsequent layer is shot. Follow ASA approved methodology in preparing the joint and applying the next layer of shotcrete.

Note: Surfaces to be treated must be pre-wet to a saturated-surface-dry (SSD) condition. Do not leave any standing water.

For more detailed application instructions, please read Technical Bulletin 105(C).

Application Details:
-- Select an Application Detail -- Crack Repair - Negative side Crack Repair - Positive side ---------------------------------- Joint Repair - Wall to wall (vertical) Joint Repair - Slab to slab Joint Repair - Wall to slab Joint Repair - Slab to wall ---------------------------------- New Cast-in-Place Joint - Wall to wall (vertical) New Cast-in-Place Joint - Slab to slab New Cast-in-Place Joint - Wall to slab New Cast-in-Place Joint - Slab to wall ---------------------------------- New Shotcrete Joint - Wall to wall (vertical) New Shotcrete Joint - Wall to wall (horizontal) - Grout only New Shotcrete Joint - Wall to wall (horizontal) - Treatment only New Shotcrete Joint - Slab to slab New Shotcrete Joint - Wall to slab (wall sits on slab) New Shotcrete Joint - Slab to wall (slab is inboard of the wall) ---------------------------------- Surface Treatment - Positive side Surface Treatment - Negative side

Back to Top